Make Wired Speakers Wireless For Traditional Sources
- Connect the audio output(s) of a source device to the audio inputs of the wireless transmitter.
- Connect the wired speakers to the wireless receiver (if amplified) with standard speaker wire.
But below are the simple steps on how to convert wired speakers to wireless:
- How to Convert Existing Speakers to Wireless Speakers.
- Step 1: Purchase a wireless speaker kit.
- Step 2: Connect an amplifier.
- Step 3: Connect the transmitter.
- Step 4: Connect the two receivers.
- Step 5: Turn on your wired speaker system.
Thick wire (12 or 14 gauge) is recommended for long wire runs, high power applications, and low-impedance speakers (4 or 6 ohms). For relatively short runs (less than 50 feet) to 8 ohm speakers, 16 gauge wire will usually do just fine. It's cost-effective and easy to work with.
Your receiver will need to include pre-outs or Zone 2 lines in order to connect powered or active speakers to it. Simply connect your speakers to the pre-outs or zone 2 outputs. You cannot connect powered or active speakers to a receiver's normal speaker terminals because it WILL damage the speakers.
Connect one end of the RCA audio Y-cable set to the "Line In" or "Audio In" ports on the rear of the wireless adapter module. Plug the other end of the audio Y-cable set into the headphone jack on the face of the old stereo amplifier or receiver.
Logitech's Bluetooth Audio Adapter, priced at a mere $40, is one of the cheapest commercial options we've seen. You plug it into your power strip, connect your powered speakers to the adapter with either RCA or 3.5mm inputs, and then pair with your Bluetooth-enabled device.
No, it wont work that way. Your sub will take a low level rca input or a high level (as in already amplified) signal from speaker wires as an input for the sub. The sub can then pass that high level input on to your speakers but it in no way will take the low level RCA input and also amplify it to speakers.
7 Best Wireless Subwoofers in 2020
- Klipsch R-10SWi 10″ Wireless Subwoofer.
- Polk DSWPRO 550wi Wireless-ready Powered Subwoofer.
- Audioengine S8 Powered Subwoofer.
- Orb Audio subMINI Small Subwoofer.
- REL Acoustics HT/1003 Subwoofer.
- MartinLogan Dynamo 700W 10″ Subwoofer with Wireless.
- Sonos Sub – The Wireless Subwoofer.
How to Use Wireless Speakers with an Old Stereo
- Place the wireless speakers in the areas or rooms in which you plan to listen to them.
- Power off the old stereo amplifier or receiver if you have not already done so.
- Connect the AC power adapter to the wireless adapter module, and then plug the other end into an available electrical socket.
Does a soundbar need a subwoofer? A soundbar doesn't need a subwoofer to sound good. Soundbars include multiple internal speakers that can sound great on their own, but a subwoofer helps produce low frequencies that many soundbars cannot.
Adding a wireless receiver to a subwoofer does not require a major redesign cost. Although the wireless subwoofer arrangement eliminates the long cable usually needed and allows more flexible room placement of the subwoofer, both the soundbar and subwoofer still need to be plugged into an AC wall outlet or power strip.
Virtually all powered soundbars (those with built-in amplification) have a subwoofer preamp output that you can connect to your Paradigm subwoofer. Just connect the wireless receiver's output to your Paradigm sub's RCA-jack LFE input, and you'll be good to go.
