Overheating is probably the number one culprit when itcomes to clipper failure. The two most common causes of heaton the Oster Classic 76 is friction and poor airflow throughthe cooling vents.
The quality of the Oster Classic 76 becomesreadily apparent through its powerful blades that cut through thickand wet hair alike without pulling or slowing. The Oster Classic76 is designed for easy maintenance and customization ofcutting. The blades easily remove and fit back into place withminimal issue.
Clipper should be oiled with each use. Q: Howoften do I need to oil my Trimmer blades? Forbest results, put one or two drops of Wahl clipperoil on the blades only when necessary, orapproximately once a month for consumer products or once a day forprofessional products.
If your clippers are used for just a few minutesa day, the blades only need to be sharpened every sixmonths. Groomers that shave dogs every single day may need tosharpen their blades every four to sixweeks.
Method: Carefully remove any mats with a slicker brush,and then brush the entire coat with a pin brush or a bristle brush.Once brushed, used a metal comb to go back and check formats. Always brush in the direction of the hair growth. Specialneeds: Grooming by a professional groomer every fourto six weeks.
While on the table, or preferably on the clipper,put one tiny drop of oil in the center of the blade on thecutting surface. DO NOT run a bead of oil across the teeth,it will seep down through the teeth and get on the coat. Start theclipper up, the oil will spread a thin coating acrossthe blade.
You should always store your clippers in adry, protective box. It is advised that you loosen the set screwbefore you put your clippers away. Also, remove the bladesand wrap them in an oiled piece of paper, so that the blade doesnot rust.
If you can't find any real hair clipper oil, youcan try vegetable oil or olive oil. Don't usesomething fancy like extra virgin olive oil — whichcan't withstand high heat — but the everyday stuff should befine.
Oster 76 blades can take pride in a 62 to66 score. That doesn't mean you should neglect your Osterclipper blades. The opposite: owning such a beautyshould inspire you to undertake proper clipper blademaintenance. Make sure you oil your Oster 76 bladesfrequently so it cuts smoothly and lasts even longer.
How To Align a Wahl 2 Hole Clipper Blade
- Slightly loosen both blade screws, just enough to be able toshift the blade.
- Align bottom blade with the top blade.
- Extreme left hand tooth of the top blade must be on the firstsmall tooth of the bottom blade.
- After blade is aligned, tighten screws.
- Plug clipper in.
To sharpen hair clippers, remove the blade fromthe clippers and run it along a 4000 grit coarse honingstone, which you can get at a home improvement or hardware store.Angle the blade and move it forward across the stone about 10 timesuntil it's shiny and even. Turn the blade over and repeat on theother edge.
To oil properly, the unit should be held in sucha way that the blades are in a downward position. With theclipper or trimmer blade running, dispense 2-3 drops ofoil across the top blade. (Use Wahl Clipper Oil ONLY!Other oils may gum up the blades).
Andis clippers also use only the best carbonsteel blades just like Wahl and evenOster.
Apply clipper oil to the tops and sides of theblade, paying special attention to the area in between the blades.Run the clipper with and allow the oil to penetratefor 20 seconds, then turn it off. Wipe any excess oil offthe outer blades to avoid the blades sticking to thehair.
