They hold a charge better, last longer, are more stable, and overall, just better batteries. Many people like to use them, but when you go to buy a battery, you don't just want to settle for any LiPo battery.
Charge your pack fully before first use. Charge your LiPo battery pack at 5C or less on the LiPo setting only. You must use a balance charging system similar to the Hyperion, Hitec, or Graupner chargers offered here at MaxAmps.
If all you want is a short rule of thumb here is it – You need 25W of charge power for each LiPo cell, for a 5amp charge rate. One 2s = 50w, one 3s = 75w, two 3s at the same time (or one 6s) needs 150w, and if you want to charge 2 6s at the same time, plan on at least 300w. Why 25w per cell, and why 5amp charge rates?
You May Also Like:
- Gens Ace. The Gens Ace batteries definitely top our list of the best LiPo battery brand.
- Turnigy. Next up, we have the Turnigy batteries.
- Zeee Power. Huizhou Zeee Power Co, Ltd., produces high-quality Li-Po, LiFePO4 rechargeable batteries and relevant accessories.
- ThunderPower.
- Venom.
- Zippy.
- HRB.
- Conclusion.
Lipo Battery Packs - Walmart.com.
I recommend: SPC 5000mAh 40C 2S Hard-case $29. Both of these brands will provide a Traxxas Connector on the battery for you.
Probably has a 3000 mah battery I'm guessing. Your get around 15-20 minutes run time. Just my 2 cents if your looking for longer run times later down the road switch to lipo and get something 5000 mah or larger. With my vxl system and a 5000 mah battery I get about 45 minutes run time.
You are free to increase the voltage of the battery you use in your RC, but you need to make sure that that voltage is within the limits of the range specified by your user manual. If you neglect to check this, you may damage your RC vehicle beyond repair.
If your RC battery is swollen or has less than 80% capacity then it is considered to have gone bad. You can still use a NiMH battery that is below 80% without any issues besides shorter run time but once a battery has started to swell up it should not be used ever again.
Conclusion. As the driver, upgrade the motor, ESC and choose a better RC car lipo battery, are the factors that make your RC car faster. Gens ace&Tattu lipo battery can give you the power and run-time you expect from the all Gens ace lipo batteries.
A 1000 mAH battery bearing a load of 500 mAH will last for about 2 hours. Similarly, if your load is 2000 mAH then it would only last for 30 minutes. A 5000 mAH battery is quoted to last for about 20-25 minutes depending on the driving speed and your driving habits.
If you have a 4-amp charger, that 3000mAh battery will be charged in about 45 minutes.
You can use any charger you like so long as it does not supply over 14.8 volts, however the charger might suffer damage if it is not capable of controlling the amperage delivered. If you charged with a 12 volt charger it might get the battery charged enough for a start but would likely take a long time.
It is difficult, if not impossible, to slow charge a NiMH battery. Harmful overcharge can occur when charging partially or fully charged batteries, even if the battery remains cold. The same scenario occurs if the battery has lost capacity and can only hold half the charge.
battery chargingIt will theoretically take one hour and 20 minutes to charge it on 2 amperes.
A trickle charger is a car battery charger designed to be left on a car for a long period of time to re-charge the battery. Some trickle chargers can be left on a battery indefinitely. These would be used on a vehicle that is not used all the time or is stored away for the winter or the summer.
In theory, you can leave the Battery Tender® Plus battery charger connected to a battery forever. That's a really long time. With a battery and a charger connected together, it's a much better idea to be proactive and anticipate problems, however unlikely they may be. In more than 99.9% of cases, nothing will go wrong.
What Is the Difference Between Battery Chargers and Maintainers? The main difference between a battery charger and a battery maintainer is that a charger applies a constant charge until it's done, which means it needs to be disconnected once the battery has been fully charged.
Leaving a battery connected to a trickle charger for too long can lead to overcharging, causing damage to the battery. Although they can't recharge a dead battery, they can be used frequently and left connected to a battery without any risk of overcharging.
Trickle ChargersYou connect the trickle charger to the battery terminal and a slow, steady stream of low-voltage electricity recharges the battery. Trickle chargers, however, do not come with the on/off feature of the float charger. Electricity continues to flow to your battery until you remove the trickle charger.
As a rule of thumb your battery charger should be a minimum of 10% of the Ah rating of the battery. E.g A 100Ah battery would require a 10 Amp charger as a minimum. To prevent overcharging you should keep the charger size to within 20% of the total capacity.
If the charging system on your bike is working properly (keeping the battery fully charged, or nearly so), then using a tender all the time is not necessary and can actually get you into trouble. It will pretty much insure that your bike will start every time when at home.
As it charges the battery, the flow rate decreases. The needle moves to the left, and into the green area. When the battery is fully charged it will indicate around 6 amps.
With the tender connected, and in a charge mode (check its lights to see what it is doing), the battery's voltage should increase to above 13 Volts, over a period of 5-10 minutes, as this indicates it is being charged by the tender, similar to what the alternator does in the bike, running down the road.
